Voice Guide; Equalizer Settings - ECG BTS Elysium M1 Black Manual De Instrucciones

Short press 2 to quickly enable Bluetooth.
2) Wireless music playback
Simply start the playback on your mobile phone or music player and listen to music from your speaker.
3) Hands-free paired with your mobile phone
Accepting an incoming call
Short press 2 to accept an incoming call.
Hang up
Short press 2 again to hang up.
Redial
Double press 2 to initiate a call to the previously called number.
Private call
Press 5 or 6 to switch between speaker and phone during a call.
Reject an incoming call
Long press 2 to reject an incoming call.
4) Disconnect an existing Bluetooth connection
The speaker will automatically pair with the last known Bluetooth device. Long press 2 to disconnect
from the current Bluetooth connection, the speaker will indicate "Device disconnected". The speaker is
then ready to be paired with another device.

3. Voice guide

Once enabled, the speaker plays information regarding the current playback mode, e.g.: Bluetooth mode, Aux
in mode, device paired, device disconnected etc.
The voice guide can be disabled by long pressing EQ 4.
4. TWS (Stereo playback)
Turn ON two BTS Elysium M1 speakers and switch both into Bluetooth mode.
Short press 3 on one of the speakers to begin searching the second BTS Elysium M1 speaker. During the
search a beep sounds and the speaker LED flashes alternately orange and blue. Both speakers are automatically
paired. After a successful pairing of the speaker that plays the left channel, the LED flashes blue and on the
speaker playing the right channel the LED is orange.
Next, enable Bluetooth on your mobile phone or other player and initiate the search for Bluetooth devices.
"BTS Elysium M1" appears, connect the speakers. When the left channel speaker is connected, it announces
"Device paired" and the LED will stop and will light up blue. You can then begin playing music on the Bluetooth
speakers in stereo mode.
Both paired speakers can be disconnected from your mobile phone/player by short pressing 3. The speaker
will indicate "TWS disconnected".
Long press 3 on any of the speakers to disable TWS. The speaker will indicate "TWS Cleared".
Note:
1. Two adapters are required for powering the speakers, one adapter for each.
2. Before pairing the speakers to use TWS, neither of the speakers shall be paired with any other device. LED
indicators on both devices should flash blue.
3. If either of the two speakers is paired with another BTS Elysium M1 speaker, you must first unpair this
connection; otherwise you will not be able to pair the speaker. Long press 3 on each speaker to delete
the existing TWS connection.

5. Equalizer settings

The default setting is normal mode. Press briefly the button 4 to switch to bass mode and press the button
4 again to switch to treble mode.
GB
35