ring RBGDC200 Manual De Instrucciones página 109

Dash Camera Troubleshooting Guide
5. Error message is displayed
5.1 'Card Full' message appears on screen
If the loop recording function is set to 'Off' this message will be displayed when the card becomes full.
To avoid this problem set the length of each video clip to 3 or 5 minutes using the procedure below. This
will ensure 'loop mode' is activated, which will automatically delete the oldest files when the card
becomes full.
For DC10/50 model – MENU > Video > Loop Recording
For DC200 model – MENU > Movie Mode > Move Clip Time
5.2 'Card Error' message appears on screen
The SD card has become corrupted. Remove the useful files then re-format the card using the camera
menu option
For DC10/50 models – MENU > Setup > Format
For DC200 model – MENU > General Settings > Format SD-Card
File transfer problems
1. Error when connecting via USB
If the error similar to below appears then the SD card may not have been correctly formatted.
Re-format the SD card using procedure below depending on camera model
For DC10/50 models – MENU > Setup > Format
For DC200 model – MENU > General Settings > Format SD-Card
2. Camera is not recognized by PC
After connecting camera to PC using the USB cable, the display should show one of the screens below
DC10/50 DC200
If this does not happen then check USB cable connections or try a different USB cable
On the PC a screen similar to below should appear to allow browsing of the camera SD card
Page | 3 Rev 1