Installation & Assembly; Grounding Instructions - Pro Force L13HPF Manual Del Operador

Installation & Assembly
WARNING
The air compressor should be turned off, unplugged from the power source, the air bled from the tank
and the unit allowed time to cool before any maintenance is performed. Personal injuries could occur
from moving parts, electrical sources, compressed air or hot surfaces. The quick connect assembly
must be attached before use. Failure to assemble correctly could result in leaks and possible injury. If
unsure of assembly instructions or you experience difficulty in the assembly please contact your local
authorized service dealer.
Assembly
1. Remove air compressor, manual, air filter
assembly, and accessories from packaging.
2. Remove the plastic plug from the compressor
intake port (see Fig 1).
3. Install the filter in the compressor intake port.
(see Fig 2).
4. Remove the oil fill cap from the crankcase and
fill until the oil reaches the top of the red dot in
the sight glass. Oil capacity is 3 oz (see Fig 3).
Use SAE 30 Non-detergent Semi Synthetic
oil (API CG/CD heavy duty motor oil). Under
extreme cold weather conditions use SAE-10
weight oil.
5. Replace the oil cap.
Fig 1 Fig 2
Estimated Assembly Time:
5 minutes
Getting Started -
Location of the Air Compressor
The air compressor should always be located in a clean, dry and well ventilated environment. The unit
should have at minimum, 12 inches of space on each side. The air filter intake should be free of any
debris or obstructions. Check the air filter on a daily basis to make sure it is clean and in working order.

Grounding Instructions

This product should be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product
is equipped with a cord having a grounding wire with an
appropriate grounding plug (see Fig 5). The plug must be
plugged into an outlet that is properly installed and grounded
in accordance with all local codes and ordinances. Check with
a qualified electrician or service personnel if these instructions
are not completely understood or if in doubt as to whether the
tool is properly grounded.
Fig 3
4
6. Apply handle to the outside compressor
saddle and line up the two bolt holes. Install
the bolts with the flat and lock washers
residing on bolts. Tighten securely.
(see Fig 4).
Fig 4
Plug
Grounding Pin
Fig 5
Grounded
Outlet