Assembling Blender; 2-Way Safety System - Magic Chef MCBL5CG Manual De Instrucciones

Assembling Blender

To use the blender, start by assembling the blender jar (3), and then place the
blender jar (3) on the motor base (6) as described below.
Assembling:
1) Put the motor base (6) on a steady and even surface
2) Place the rubber seal ring on the blade assembly (4).
3) Position the blade assembly (4) on the inside of the blender jar(3).
4) Turn it counter-clockwise to lock it tightly into position. Important: The blade
is sharp. Handle carefully.
5) Position the blender jar (3) on the motor base (6) and turn it clockwise to
lock it into position.
6) Position the lid (2) on the blender jar(3) Note: The tail of the lid should be
placed on the slot at the top of the handle as per 2-way safety system

2-Way Safety System

1) Safety lock on lid :
When lid is removed, the blender will stop operation. When positioning the
lid on the blender jar, note that the tab on the lid should be put into the slot
on the top of the handle to lock it into position.
2) Safety lock between the blender jar assembly and the motor base:
When the blender jar is detached from the motor base, the unit will not
operate. Align the arrow on the blender jar with the arrow on the motor base
of the unit. This is achieved by turning the blender jar clockwise, until the
blender jar snaps into place when the arrows are aligned.
3) With the 2-way safety system, it is only possible to operate when both the
blender jar and the lid are located in the proper position.
6