Cleaning And Care - MaxxGarden 21687 Manual De Usuario

OPERATION AND TURNING ON THE TERRACE HEATER
A. Turn the knob to OFF.
B. Slowly open the valve of the gas bottle.
C. Push the control knob in and turn it counterclockwise.
D. Hold down the control knob and press the ignition button (Ignitor) several times.
When the pilot ignites, keep the control knob pressed for another 10-20 seconds.
E. If the pilot does not continue to burn, repeat steps C and D.
F. Turn the control knob to LOW and wait 5 minutes or more before moving the knob to the
desired position.
G. If the heater turns off unintentionally or is blown out by the wind, turn off the patio burner and
wait 5 minutes before re-igniting.
TURNING OFF THE PATIO HEATER
A. Turn the control knob to the OFF position.
Close the valve on the gas bottle completely.
NOTE
- lf a new tank has just been connected, please allow at least one minute or more for the air in the
gas pipeline to purge out through the pilot hole when lighting the pilot flame make sure that the
control knob is continuously depressed While pressing the igniter button. Variable control knob
can be released after the pilot flame lit for 20~30 seconds.
- Pilot flame can be watched and checked from the peephole located on
the base of burner.
- If the pilot flame does not light or it goes out, repeat step 3.
- If the burner flame goes out accidentally or it is blownout by wind,
turn off the heater and wait at least 5 minutes or more to let the gas
dissipated before relighting to avoid possible gas explosion. Repeat steps 2 to 4.
- Failure to follow this lighting procedure may result in flame roll out beyond the emitter grid.
TO TURN OFF THE HEATER.
Press and turn the control knob to OFF position.
Turn off the valve on the gas cylinder and disconnect the cylinder.
STORAGE
- Always close the gas valve of the LPG Gas Cylinder, after use or in case of a disturbance.
- Remove the pressure controller and the hose.
- Check the tightness of the gas valve and tor damage. lf you suspect damage, have it changed
by your gas dealer.
- Never store LPG Gas Cylinder in a sub-terrain, or at places without adequate air ventilation.

CLEANING AND CARE

- Wipe off exterior surfaces with soft, moist rag and soap water. Do not clean heater with cleaners
that are combustible or corrosive.
- Remove debris, spider and insect nests trom ventilation opening of the LPG Gas Cylinder enclose,
control compartment, burner and circulation air passageways of the appliance with heavy-duty
pipe cleaner or compressed air to keep appliance clean and safe tor use. Never clear ports or
other openings with toothpicks or other article that will break and block the ports.
- Do not paint the flame screen, control panel or reflector.
- Cover the burner unit with the supplied protective cover when the heater is not in use. Wait until
the appliance is cool before covering.
- In a salt-air environment, such as near an ocean, corrosion occurs more quickly than normal.
Check trequently tor corroded areas and repair them promptly.
CONNECTING GAS LINE TO LPG GAS CYLINDER
CAUTION: The gas governor, flexible rubber pipe and clamps are not supplied
with this appliance and must be used proper ones, according to National Rules
in force. The gas governor has to be set tor 28-30/37/50 mbar. Connect appliance
pipe holder with proper flexible gas rubber pipe and fix it using proper clamps.
lf some gasket is needed, it must be according to Standard EN 549. lf other
material to guarantee tightness could be used,they must be in line with Standard
EN 751 only. Check the gas tightness with soap water each time you connect
the pipe according to "Leakage Test".