Reese Towpower 74407 Lea, Comprenda, Siga Y Guarde Estas Instrucciones página 2

3/16"
Pivot Tube
3/16"
Beveled Side
Non-beveled Side
To attach a handle assembly:
1) Insert the long spacer into the roller followed by
the thin spacer and the bolt.
2) Secure to the crank stem with the nut provided.
Roller
Spacers
Nut
The following procedures should be performed at least annually:
For side-wind models, the internal gearing and bushings of the jack must be kept lubricated. Apply a small amount of automotive grease to the internal
gearing by removing the jack cover, or if equipped, use a needle nose applicator or standard grease gun on the lubrication point found on the side of the jack
near the crank. Rotate the jack handle to distribute the grease evenly. A lightweight oil must be applied to the handle unit at both sides of the tube for side-
wind models. If equipped, the axle bolt and nut assembly of the caster wheel must also be lubricated with the same light weight oil. For top-wind models,
apply a lightweight oil to the screw stem. If this product is used in a marine environment, flush the jack assembly and bushings with fresh water, and apply
fresh lubricant.
Grease
Oil
Cequent Consumer Products, Inc., 29000-2 Aurora Road, Solon OH 44139
Toll Free: 1-800-234-6992, 1-800-354-5505
Ph: 1-440-498-0001, Fx: 1-440-498-1038
Technical Support: 1-800-510-9772
www.ReeseBrands.com
Installation Instructions (Cont.)
Weld-on Pivot Tube Mounting
Instructions (Round and Square
Pivot Tubes):
1) All welding must be per-
formed by an AWS certified
welder.
2) The non-beveled side of the
pivot tube is welded to the
tongue unless otherwise
specified on hardware.
3) Place the weld-on pivot tube
Pivot Pin
against the tongue and weld
all around with a 3/16" fillet
weld. Align one set of pivot
mount holes vertically.
4) Mate the jack to the pivot tube
and secure with the supplied
pin.
To attach a wheel assembly:
1) Insert the long spacer into the wheel.
2) Set the wheel into the caster body and place the
bolt through the caster body and wheel.
3) Secure with the nut provided.
Bolt
Oil
Removable Caster
Nut
Spacer
Bolt
Maintenance
Grease
Oil
Drop Foot
Plunger Pin
Heavy Duty Caster:
1) Jack capacity limited to
lesser of jack or caster.
2) Use 4 3/8 bolts, washers,
and lock-nuts as shown.
Oil
Oil
Outer Tube
Inner Tube
Drop Leg Pin
Drop Leg
Foot Plate
74407IN 05/16