Publicidad
Idiomas disponibles
Idiomas disponibles
EN
PRECAUTIONS
•
Do not attempt to disassemble or modify the device
• Strictly follow the requirement of power source
• Do not expose this device to temperatures out the range of
-30 °C to 60 °C for operating and -35°C to 60°C for storage
• Do not expose this device to environments outside of the
following humidity range: 10-90% RH (non-condensing)
• Please strictly follow the instruction to install or hire
professionals to install properly
PACKAGE CONTENTS
1 x Installation Bracket
1 x GDS3710
6 x Back Panel Screws
3 x Rubber Gaskets
4 x Anti-tamper Screws 1 x Anti-tamper Hex Key
1 x RFID Card
1 x Frame Back Cover
1 x RFID Key Fob
1 x Wiegand
6 x Bracket Screws
and Anchors
Cable
1 x Drilling Template
1 x Quick Installation Guide
1 x GPL License
~
~
1
MOUNTING GDS3710
On-Wall (Surface) Mounting
Step 1:
Refer to the "drilling template" to drill holes at targeted place on
wall then mount the installation bracket using the four screws and
anchors provided (screwdriver not provided). Connect and tight-
en "Ground" wire (if available) to the bracket ground marked with
printed icon
.
Step 2:
Pull Cat5e or Cat6 cable (not provided) through the rubber gasket
selecting the correct size and the back cover panel piece, please re-
fer to "GDS 3710 WIRING TABLE" at the end of QIG for Pin connections.
Note:
Needle nose plier highly recommended and 2.5mm flat screwdriver
required (not provided). Stripping outer plastic shield of the cable
in less than 2 inches suggested. Do NOT leave bare metal outside
the socket by over stripping the inner plastic shield of the wires.
~
2
~
Publicidad
