COPELE IM-70401 Guia De Inicio Rapido

liv e s to c k e q u ip m e n t
TOP
CONNECTION
RECOMMENDED
HEIGHT
BOTTON
CONNECTION
www.copele.com - Tlf. +34 968 88 27 25 - Fax. +34 968 88 02 02 - El Palmar 30120 - MURCIA - ESPAÑA
ASSEMBLY INSTRUCTIONS
PUSH DRINKER FOR HORSES
Cod. IM-70401 / Cod. IM-70666 / Cod. IM-70667
Installation
Its installation is very simple; you just have to fix
it on the wall using lag screws. Mount the ½ "plug
supplied in the outlet opposite the water inlet.
Possibility of upper or lower connection with ½
"male.
Mesurements:
Front 22 cm. / Background 28 cm. / Height 18 cm.
Recommended height:
Recommendations:
-Try not to place it under direct sunlight so that the
water does not heat up.
-Keep the drinker clean.
Screws:
Anchors ∅12x60 mm
-
Lag screws DIN571 ∅8x70 mm
-
nº
SKETCH
1 DRINKING BODY
2 O-RING BOARD
3 1/2 "CAP
4 SENSOR SPRING
5 STAINLESS STEEL
6 OCRE CLOSURE BOARD
7 FEMALE NUT
8 PROTECTOR VALVE DRINKER
9 STAINLESS WASHER
10 M6 STAINLESS NUT WITH BRAKE