Vox Mode; Reception; Scan - Team Electronic TS-11VI Manual De Instruccion

English TEAM TS-11vi
For PTT transmission hold the PTT key while talking at a distance of approxi-
mately 10 cm into the microphone. For details about the VOX mode, see the
section VOX mode.

VOX Mode

VOX stands for voice-operated-transmission, i.e. no PTT key is needed for
transmitting a signal. This feature allows hand-free operation. In some Euro-
pean countries, for the driver of a vehicle, it is no longer permitted to operate
mobile devices for communication while driving if hand-operation is required.
To activate/deactivate the VOX mode, press the transmission key [PTT] and
the menu key [EMG] (4) concurrently. The active VOX mode is indicated by
the microphone symbol in the LCD, which blinks in transmission mode.
We recommend to test the VOX operation while deciding for the best location
of the microphone in the vehicle. For best results you should be able to talk
directly into the microphone.
The VOX sensitivity and the delay time can be adjusted in the menu (see
menu "VOX L" and "VOX T").
Please note that the VOX function cannot work if the squelch is open.

Reception

The received signal is audible in the speaker of the radio. The s-meter in the
LCD indicates the signal strength.
Please note that the TS-11vi is equipped with CTCSS/DCS. If CTCSS/DCS is
activated for the actual channel, received signals with non-matching CTCSS/
DCS codes are not audible in the speaker. In active mode, the according sym-
bol CTCSS or DCS are displayed in the LCD.

Scan

The scan function searches for signals on the actual frequency norm in the
selected modulation mode (AM/FM). Once a signal has been detected the
scan function pauses according to the selected scan mode (squelch/time)
before it automatically returns to active scanning.
To activate the scan function, hold any of the channel selectors until the
symbol SCAN appears in the LCD. All channels are scanned continuously, in
consecutive order. To stop the scan function, push the PTT key.
Once a signal is present the scan function pauses,
in squelch mode : until the signal ends plus the delay time of a few seconds,
: for approx. 10 seconds, regardless whether the signal has
in time mode
ended or not. Then, the scan function continues.
Note: you can change the scan-direction during scanning anytime by pressing
the according channel selector key Up [p] or Down [q].
24