How To Use - IRIS WOOZOO DHM-DDC50 Manual Del Usuario

HOW TO USE

Make sure the water tank has been securely installed into the main body. If tank is not properly installed, the Tank Full/Not
Inserted indicator light will turn on and the product will not operate.
1. Place the Product
Place the product upright on a stable surface and insert the power
plug into the electrical outlet.
2. Start the Product
Press the power button to turn the product on. The product will start running
at the last setting used if the power plug has not been pulled out.
3. Select the Operating Mode
Pressing the dehumidifier button changes the dehumidification level.
High Medium Low Dehumidifier Off
Pressing the air flow strength button changes the air flow strength of the fan.
High Medium Low Circulator Off
If product is turned off during oscillation, operation will stop once product is
facing forward. The oscillation indicator lights will blink until product returns to
the forward facing position.
The circulator fan and dehumidifier can be run together or on their own.
Air from the dehumidifier air outlet may cause the fan vane to rotate even when
the circulator fan is not running.
4. Stop the Product
Press the power button during operation to turn the product off.
All indicator lights turn off when the product is turned off.
When the dehumidifier is turned off, air flow will continue to run for up to 4
minutes. The dehumidifier indicator lights will blink until product stops
running. Please do not unplug the power plug until the product stops
operating.
When the air flow strength and dehumidifier buttons are used to turn the
product off, the product will remain in stand-by mode and can be restarted by
pressing either button. After 30 seconds, please press the power button to
turn the product back on.
7
Select Oscillation
Horizontal Oscillation
Press the button to turn on the left and right oscillation.
Horizontal oscillation operates across a 50 degree range.
If product is turned off during oscillation, operation will stop once product is
facing forward. The oscillation indicator lights will blink until product returns
to the forward facing position.
NOTE:
The left and right oscillation cannot be done
manually. Please use the oscillation button
to change the angle of the product. Forcibly
changing the angle will damage the product.
Vertical Oscillation
Vertical oscillation can be adjusted manually across 6 steps from horizontal to
approximately 90 degrees.
Start Timer
While the timer is running, the indicator light will change according to time
remaining. When time runs out, the product will turn off and stop running.
Pressing timer button changes the preset time as follows:
8 (h)
Timer Off
2 4
When the water tank is full or when it is not installed correctly, the indicator
light turns on and the timer and product shut off. After the tank is emptied and
properly installed, timer will resume where it stopped.
Pressing the power button or unplugging the product while the Tank Full/Not
Inserted indicator light is on will reset the timer.
8