Publicidad
Idiomas disponibles
Idiomas disponibles
security
Made in Italy
BT2014/35/UE
EMC2014/30/UE
Twin channel microprocessor remote control with MM53200 UM86409 UM3750 coding
Up to 4096 different codification through 12 programmable bit setting without dip switch
Independent transmission of each code associated with key A or key B
Power supply with 12 volt battery (included)
Estimated battery life: minimum 2 years ( max 1 minute/day operating )
Led lighting indication when radio transmission is active
Current consumption in standby mode 1,5 ìA
Current consumption in transmission mode 22 mA
Operating radio frequency 433,92 MHz
Dimensions (WxHxD) 62x35x18mm
The TWIN allows the independent set-up for each of 2 channels;
code + 2 bit channel on each key.
Set up operation has to be repeated for every key of the radio remote control .
In order, to active set-up operation, you have to push together both the keys for some seconds , until led switch
on, then you have to leave them ; now you are in set up configuration mode and you can choose between the
following two procedure
:
CODE MEMORIZATION
NOTA:during the programming, if some key is not pressed in order the at least 5 second LED is extinguished
and the phase of programming finishes automatically
For insert the code you have to access with digit the following sequence: "1" - "1" - "0" - "0"
Now insert sequence of 10 bit digital code pushing ten times key A or key B according to the
following rule :
Press key B (right button)for "0" bit value;it is equivalent to setting dip
switch "OFF" in the previous TWIN version.
Press key A ( left button ) for "1" bit value; it is equivalent to setting dip switch "ON"
in the previous TWIN version
Now insert sequence of 2 bit digital channel pushing two times key A or key B according to the following
rule
:
For Channel A press "1" - "0": it is equivalent to using left button in the previous TWIN version.
For Channel A press "1" - "1": it is equivalent to using left button in the previous TWIN version.
Finally you have to assign a button to use : press key A or key B to link the code inserted above , with the
Desired button.
When this procedure ends , led switches off.
*
For example if you want configure a new code or duplicate an old TWIN remote control equipped with dip switch as in the following
figure, you have to press the following buttons sequence
You have to digit the following buttons sequence:
1
1
0
0
Access
1
1
0
0
Access
CODE DISPLAY
For read the code you have to digit:
To activate display procedure, press the following key sequence :"1" - "0" - "1" -"0"
Now choose key A or key B to display code linked with that key
Led switches off for a brief time then a sequence of 12 blinks (one blink for each code bit) starts according to the following rule:
A single brief blink means bit value
A single brief blink means bit value
BATTERY REPLACEMENT
To open plastic box enclosure, unscrew the screw placed bottom radio remote control.
To remove the old battery.
To insert of one new respecting the polarity indicated on the container.
Check radio remote control works correctly.
2
Lead free
Pb
RoHS
compliant
.
1
2
ON
OFF
1
0
0
1
1
0
1
code
1
0
0
1
1
0
1
code
"0"
"1"
VHF twin channel radio-control
It's possible to
5
3
4
6
7
8
0
0
1
1
0
channel A
0
0
1
1
1
channel B
memorize a different 10 bit
9
10
assigned to 1 button
assigned to 2 button
TWIN
A A
B B
"1"
"0"
1
0
Publicidad
