Descargar Imprimir esta página
Rockwell Automation Allen-Bradley 140G-R Instalación
Rockwell Automation Allen-Bradley 140G-R Instalación

Rockwell Automation Allen-Bradley 140G-R Instalación

Publicidad

Enlaces rápidos

140G-R-EP
IP54 protection for 140G-R
Protezione IP54
Durchsichtige Schutzabdeckung
Protection IP54
Protección IP54
Installation - Installazione - Instalación
Instalação -
WARNING:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG:
Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
DIR 1001000R0714 (L7789)
-
A
140G-R
B
Bul. 140G
2
C
x18
ONLY 13 NEEDED
FOR INSTALLATION
1

Publicidad

loading

Resumen de contenidos para Rockwell Automation Allen-Bradley 140G-R

  • Página 1 Bul. 140G 140G-R-EP IP54 protection for 140G-R Protezione IP54 Durchsichtige Schutzabdeckung Protection IP54 Protección IP54 Installation - Installazione - Instalación 140G-R Instalação - WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants. (Follow NFPA70E requirements).
  • Página 2 DIR 1001000R0714 (L7789)
  • Página 3 Ø 0.22 " 5.91 " 10.08 " Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. DIR 1001000R0714 (L7789) Publication 140G-IN115A-MU-P - April 2013 Copyright © 2013 Rockwell Automation, Inc. All Rights Reserved.