Troubleshooting; Warranty Statement; General Considerations - PROZIS Voodoo Racer Manual Del Usuario

Gesture controller function: see page 2, figure D.
1. One-key transformation: see page 2, figure D1.
2. Fingertip button: Short press - deformation (figure D1) / Long press - cooperation with the
palm to control left and right rotation.
Gesture controller charging: see page 2, figure E.
Connect the USB charging cable to the corresponding socket. The LED light will remain on
while charging and will switch off when it's finished. Charging time is about 10-20 minutes:
see page 2, figure E1.
Performance tips: see page 2, figure F.
1. Press and hold the power button on the controller, then switch on the remote control.
2. Hold the gesture controller horizontally as far as possible, and slowly tilt it forward/back/
left/right (the angle must be greater than 15 degrees) to control the forward/back/left/
right features of the remote-control car: see page 2, figure F1.
3. Press and hold the fingertip button, and turn your fist to the left. Now you can control the
car to make the left steering rotation. When you move your fist to the right, you can control
the car to make the right steering rotation: see page 2, figure F2.

Troubleshooting

Some issues that arise may be solved by the user. If the problem persists after having tried
the following solutions, please contact Prozis customer service.
PROBLEM
The device is not responding.
The device is slow to respond or
difficult to maneuver.

Warranty Statement

All electrical and electronic products commercialized by Prozis via www.prozis.com are
covered by the warranty applicable to the purchase and sale of consumer goods.

GENERAL CONSIDERATIONS

This document contains the terms and conditions of Prozis' warranty for final consumers.
This warranty is valid exclusively for consumers who purchase the product for non-
professional purposes.
CAUSE
The car's battery is low.
The transmitter's battery is low.
Wrong transmission frequency.
The transmitter's battery is low.
Interference from another R/C vehicle.
SOLUTION
Charge the car's battery as described.
Charge the transmitter's battery as
described.
Make sure the car and the transmitter
are on the same frequency.
Charge the transmitter's battery as
described.
Calibrate both the car and the
transmitter by restarting both.
EN
7