Steren COM-841 Manual De Instrucciones página 40

Power Save Mode - Please select the power save mode in the
drop-down list.
• Maximum - Selects maximum mode to let the access point buffer
incoming messages for the Adapter. The Adapter will detect the
access point if any messages are waiting periodically.
• Normal - Normal mode uses maximum when retrieving a large
number of packets, then switches back to power save mode after
retrieving the packets.
• Off - Turns power saving off, thus powering up the Wireless USB
Adapter continuously for a short message response time.
Network Type: There are basically two modes of networking:
• Infrastructure - All wireless clients will connect to an access point or
wireless router.
• Ad-Hoc - Directly connecting to another computer, for peer-to-peer
communication, using wireless network adapters on each computer,
such as two or more COM-879 wireless adapters.
Antes de utilizar su nuevo Kit C
An Infrastructure network contains an Access Point or wireless
router. All the wireless devices or clients will connect to the
wireless router or access point.
An Ad-Hoc network contains only clients, such as laptops with
wireless desktop adapters. All the adapters must be in Ad-Hoc
mode to communicate.
Wireless Mode: Specifies 2.4 GHz 300 Mbps, 2.4 GHz 54 Mbps or
2.4 GHz 11 Mbps operation in an access point network. The Wireless
adapter must match the wireless mode of the access point with which
it associates.
Wireless Mode when Starting an 3Ad Hoc Network: Specifies 2.4
GHz 300/54/11 Mbps to start an Ad Hoc network if no matching
network name is found after scanning all available modes. This mode
also allows the selection of the channel that the Wireless Adapter
uses. The channels available depend on the regulatory domain. If the
adapter finds no other ad hoc adapters, the channel that the adapter
starts the ad hoc network with will be selected automatically. The
Adapter must match the wireless mode and channel of the clients it
associates.
802.11 Authentication Mode: Select which mode the Adapter uses to
authenticate to an access point:
ENGLISH-13