Publicidad
Idiomas disponibles
Idiomas disponibles
5413010-Farbspritz-man_a 23.03.12 13:12 Seite 68
• When using outside closed rooms,
use a mains cable extension designed
for this.
• Always work in a concentrated manner!
Use your common sense! Take a break
if you get tired of working.
• Repair work should only be done by
appropriately qualified specialists. When
exchanging individual parts, only use
original parts or those expressly
recommended by the manufacturers
in order to largely preclude any
potential danger.
• Do not spray highly inflammable
liquids with this appliance.
• Do not clean the appliance with
inflammable solutions.
DANGER! Risk of explosion or
catching fire with paints or
thinners! Injuries and serious damage
might ensue! Rule out where possible
any potential ignition sources, such
as sparks, naked flames, cigarette
lighters, cigarettes.
DANGER! When inhaled, paints
and thinners have a toxic effect!
Giddiness, fainting or other symptoms
of poisoning may ensue!
DANGER! Never pull the plug
from the power socket by the
cable! Danger of electric shock!
ATTENTION! In case of injury,
immediately consult a specialist
doctor.
68
7 – Handling instructions/
Preliminary work
ATTENTION! First of all, make a
test application!
After mixing the paint, check the atomised
spray from the spray gun on scrap paper
to get a feeling of how the spray gun
works.
Always ensure that the distance to the
surface you are working on is about
30 cm.
1. Check to see whether the intake tube
has been firmly installed in the pump
housing. Check the atomiser valves
and the secure fitting of the discharge
nozzle.
2. The pressure of the liquid output can be
checked using the control knob (3).
Turn the knob clockwise to increase
the pressure. Turn the knob counter
clockwise to reduce the pressure. Select
a central setting and find the appropriate
pressure while test spraying.
With water discharge
• Paints on a water basis: Add thinner
or mix with another low-viscous paint.
• Oil paints: Thin paints.
General spraying tips (Fig. 3)
1. The 0.5 mm discharge nozzle that is
preinstalled at the factory is
completely adequate for most paint
applications in and outdoors.
2. Use the 0.8 mm discharge nozzle for
more viscous and thick latex paints.
3. Should the mist discharged seem
very slight and unbalanced as far as
Publicidad
Capítulos
