Troubleshooting
Symptom
Battery LED light does not illuminate when
remote buttons are pressed.
Auxiliary lights/equipment not operational
when the remote control button is pressed
and the red LED illuminates.
Some accessories/lights will not come on.
Light/accessory comes on momentarily.
In case the remote is lost, a replacement remote can be paired with the existing module, rather than
purchasing a new system (call customer service at 800-241-3808 for assistance). Pair the new remote
to the main unit before use.
Pairing procedure (See
FIG 3
shipped – call 800-241-3808 before trying to pair a newly purchased C3050K, WMS).
•
Point the remote control towards the main unit and using a small screwdriver press the black
switch. The green light will light up on the powered WMS unit.
Now press any one of the eight buttons on the remote control to pair the remote with the WMS.
•
The green light should turn off indicating successful pairing.
Call customer service at 800-241-3808 for any issues related to your WMS.
Tiger Accessory Group LLC
,
Long Grove IL 60047
,
.
.
www blazer-international com
C3050K • WIRELESS MANAGEMENT SYSTEM • OWNER'S MANUAL
Remote control battery is dead.
Replace battery (12V A23 alkaline) – If new battery
- call 800-241-3808
1. Vehicle battery voltage below 9.8V +/- 0.3V DC.
Charge battery.
2. Main unit not connected/ incorrectly connected
to the battery source. Check connection and
polarity of WMS.
3. Blown fuses/Replace fuses.
4. Pairing between the remote and main unit
disrupted. Pair the system (see below).
Check wire polarity for those items.
That channel is being overloaded. Make sure the
amperage of the light is less than that stated at
the terminal (check fuse).
): (Caution: Main unit and remote control are already paired when
BLAZER INTERNATIONAL COM
-
Possible Cause and Solution
FIG 3
1
Indicator Light Green
2
Pairing Switch Black
Patent Pending • Brevet en attente • Patente pendiente
.
1-800-241-3808
(
)
(
)
Page 3 of 12
© Copyright 2016