Important - Össur Iceross Curvemaster Instrucciones De Uso

Instructions For Use
Iceross Curvemaster
K-220000
Instructions for replacement and adjustment of cutting wheels
1. Remove the stop screw on the handle using a 3 mm hex key. Hold the upper wheel and
unscrew the handle. Pull out the upper axle. Remove the lower axle by unscrewing the
hex bolt using an 8 mm hex key and a 16 mm open-end wrench.
2. Remove and replace the upper cutting wheel using a 4 mm hex key and a 16 mm open-
end wrench.
3. Remove and replace the lower cutting wheel using a 5 mm hex key and a 16 mm open-
end wrench.
4. Insert the upper axle and screw the handle on while holding the axle. Secure with the
stop screw. Insert the 10 mm bolt and place the lower axle against it, making sure the
threaded hole points upward. Hold the axle in place while tightening the bolt with an 8
mm hex key. Do not fully tighten.
5. Press the lower cutting wheel inwards, compressing the spring.
6. Keep pressure on the lower cutting wheel and turn the lower axle with a 16 mm open-
end wrench until the lower cutting wheel contacts the rubber ring on the upper cutting
wheel. The upper cutting wheel should overlap the lower cutting wheel by 1 mm.
7. Using a 16 mm wrench, hold this setting and secure the lower axle with an 8 mm hex
key.

8. IMPORTANT:

Make sure the lower cutting wheel is seated against the edge of the upper cutting wheel
before turning the handle.
2
ENGLISH