Troubleshooting - SUNTEC DryFix 20 Design Manual De Instrucciones

Continuous drainage
- Take the drainage hose out from the water tank.
- Find the drainage opening on the back of the device.
- Cut out the stopper
- Put the drainage hose into the opening, put the other end of the hose into a collecting vessel
and pour out the water.
- Make sure that the hose is securely connected to prevent leakage of water.
MAINTENANCE INSTRUCTION
1. Please always unplug the unit before cleaning.
2. Please note that only the dust filter may be cleaned.
3. Remove the front cover and carefully remove the dust filter.
4. If the filter is only slightly dusty, you can quickly and easily clean it with a vacuum cleaner.
5. Rinse the filter under running water (max. 40 ° C) and dry it with a soft cloth.
6. Clean the appliance with a damp cloth and then wipe with a dry cloth.
7. Do not use chemical solvents (such as benzene, alcohol) or hot water.
8. If the unit will not be used over longer period, please turn the power off, unplug the power cord
and take the unit in a dry, cool and safe place

TROUBLESHOOTING

Problem
Hot air comes from the air outlet
The unit does not work.
The device does not
dehumidify.
The air does not flow out.
Loud noises during start up.
SPECIFICATIONS
MODEL
SPECIFICATION
DEHUMIDIFICATION
(litre/day, 30°C and RH 80%)
Cause
-----------
Is the unit plugged in?
Does the "tank full" indicator
(water tank is full or misplaced)
light up?
Is the air inlet or outlet blocked?
Is the ambient temperature or
relative humidity too low?
Is the air filter dirty?
Is the function of the internal
drying activated?
If the device was placed awry or
unstable?
Is the air filter dirty?
DryFix 20 Design
20 l
Solution
The dehumidifier has no cooling
function; the air comes out of
the condenser. This is not a
defect.
Plug in the unit.
Empty the water tank and set it
to the correct position again.
Check the air inlet and outlet
and remove any obstructions.
Please check the settings.
Clean the air filter as described
in the manual.
Wait until the process is finished
Place the unit on a stable flat
surface.
Clean the air filter as described
in the manual.