FOOT CONTROL SWITCH
For All Hand-Operated Trolling Motors
Installation Instructions
12V or 24 VDC / 50-28101
INTERRUPTOR CONTROLADO CON EL PIE
Para Todos Los Motores Electricos Manuales
Instrucciones Para Instalar
De Paso Lento 12V o 24 VDC / 50-28101
INTERRUPTEUR DE CONTRÔLE AU PIED
Pour Tous Les Moteurs De Traîne Manuels
Instructions d'Installation
De 12v ou 24v / 50-28101
We recommend a full service marine dealer install this product to insure
NOTICE:
proper fit and trouble free operation. These instructions should be placed with
product for the owner's future use.
Disconnect all battery cables at battery before attempting to install this
WARNING:
product.
Select location for foot control switch that can be operated easily with foot
STEP 1:
while fishing. Normally for bow mounts a foot switch is mounted on both sides of front
casting seat for easy operation. Check location to make sure that there are no
obstructions under deck.
For deck mount or front platform installations, drill a 3/8" dia. hole and run
STEP 2:
wire from switch down thru hole. Place switch housing flat down on casting deck and
using housing as drill template, mount switch to deck using either #10 pen head
screws or 3/16" dia. pop rivets (not furnished).
Hook up wire per diagram.
STEP 3:
All electrical connections should be protected with tape or rubber covering to
NOTE:
prevent possible shorting.
All trolling motor wiring systems must be fused at the battery for safety and
NOTE:
protection. To prevent loose and corroded connections, all joints should be soldered.
Reconnect all battery cables and check for proper operation.
STEP 4:
Maintenance inspection is the owners' responsiblity and must be performed as
follows:
NORMAL SERVICE:
SEVERE SERVICE:
Operation in salt water areas is considered
NOTE:
1. Check mounting hardware for adequate tightness.
2. Check all electrical connections.
3. Check wire for abrasions or cuts, replace if necessary.
MAINTENANCE INSTRUCTIONS
Every 50 hours of operations
Every 25 hours of operation
"SEVERE SERVICE."