Tripp-Lite DWF3770L Manual Del Propietário página 5

1b. Solid Brick and Concrete Mounting
• When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 35mm (1-3/8") for using the concrete anchors. Do not drill into mortar
joints! Be sure to mount in a solid part of the block, generally 25mm (1") minimum
from the side of the block. It is suggested an electric drill on a slow setting be used
to drill the hole instead of a hammer drill to avoid breaking out the back of the hole
when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
13-10-124-9332E3.indb 5
Concrete Anchor
D6 Washer
Anchor Bolt
WARNING
5
1
Mark the
exact location of
mounting holes
2
Drill pilot holes
Screw the wall
plate onto the
wall
11/19/2013 4:30:48 PM