Zyxel DMA-2500 Guia De Inicio Rapido página 9

Configure the DMA-2500
1. Turn on the TV and set its video source to the DMA-2500's
connection: HDMI, S-Video, YPbPr, or composite (AV).
2. Turn on the DMA-2500. The POWER light turns green.
Check your power connection if the power light does not
come on.
3. Install the remote control's batteries.
Point the remote at the black dot on the front of the DMA-2500. The
DMA-2500 remote is sensitive to input from the remote. Holding a button
on the remote down may register as multiple pushes.
4. If the DMA-2500's picture displays on the TV properly, continue to the
next step. Otherwise, use the remote's OUTPUT button to change the
video mode. Wait a few seconds during each mode. When you get to
the correct mode, use the arrow and OK buttons to select OK.
ENGLISH
9