Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect the shielding of the cable to the ground
contact of the plug, and always make certain that the shielding does not come into contact with the housing of the XLR plug. If the shielding
is connected to the ground, this can lead to short-circuiting and system malfunctions.
Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.
TECHNICAL SPECIFICATIONS
Item number:
Product type:
Maximum air flow:
Air speed:
Fan speed:
Fan diameter:
DMX input:
DMX output:
DMX mode:
DMX functions:
Standalone functions:
Controller:
Control elements:
Display elements:
8
1
3
2
CLIA2000PRO
Wind machine
56 m³/min.
12 m/s
440-2500 U/min
310 mm
3-pin XLR male
5-pin XLR male
3-pin XLR female
5-pin XLR female
1-channel
Fan control
Fan control
DMX512, RF remote control
START/STOP (MODE), UP, DOWN (backlit)
3-digit LED display
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
4
3
3
2
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
1
Publicidad
Tabla de contenido
