Safco TASK MASTER SIIH Instrucciones De Ensamblaje

an LDI Company
New Hope, MN 55428
Visit us on the web:
www.safcoproducts.com
PARTS LIST
CODE
DESCRIPTION
o
A Glide
o Base
B
o
C Cylinder
o
D Foot Ring
o
E Dust Cover (3 pc set)
o
F Seat Assembly
o
Back Assembly
G
o
H Knob with Cone Point
o
I Back Support Bar
o
J Knob with Flat Point
Check all parts against Parts List before
beginning assembly. Allow all parts to warm to
room temperature prior to assembly.
Install a A Glide into each of the legs of the B Base. o
1
Press firmly into place. Be sure the glide is inserted
completely into leg for proper stability.
2 Insert the C Cylinder into the base, tapered end down. o
Secure the cylinder by applying a little downward pres-
sure (CAUTION: When applying downward pressure,
avoid plastic button at top of cylinder, as pressure will
release pneumatic lift)
o
3 Slide D Foot Ring on to cylinder (ring side up), posi-
tion at desired height. Turn knob to secure. Place E
Dust Cover over exposed cylinder.
o
Install the F Seat Assembly by aligning the hole on
4
the underside with the shaft of the cylinder assembly;
push down firmly on seat.
5 Slide I Back Support Bar into bracket on underside of o
seat assembly. Use a standard screwdriver to depress
push button near end of Back Support Bar and slide
Bar until push button locks into bracket. Remove H
Knob with Cone Point from parts bag. Thread Knob
into bracket and tighten to secure Back Support Bar in
proper position.
6 Make the final chair adjustments following the instruc-
tions on the reverse side.
5110-37MP: 1 of 6;
Rev. 2: 12/03
TASK MASTER
A S S E M B L Y
PRODUCT WARRANTY CARD is available online at: www.safcoproducts.com
QTY. PART NO.
5 5110-25
1 5100-04
1 5110-11
1 5110-06
1 5110-14
1 5110-51
1 5110-52
1 6680-78
1 6680-55
1 6680-77
o
For questions or concerns, please call the
available Monday-Friday 8:00 AM to 4:30 PM (Central Time) (English-speaking operators)
INDUSTRIAL CHAIR
®
(19” - 27” Range)
I N S T R U C T I O N S
TOOLS REQUIRED: Standard Screwdriver
o
J
o
I
o
H
o
o
D
o
Safco Consumer Hot Line
Registered U.S. Patent D381,823
o
G
PARTS SHOWN IN BOX
ARE PRE-ASSEMBLED
o
E
NOTE: REMOVE
PLASTIC CAP
5110
o
F
o
C
o
B
o
A
1-800-664-0042