Style selections 2065NNMV Guia De Inicio Rapido página 5

ASSEMBLY INSTRUCTIONS
3. Place the assembly in the desired location and
mark the mounting points on wall through the
holes in the back tubes of the unit.
NOTE: Wall anchors (EE) should be oriented
with the flat side horizontal.
Hammer the wall anchors (EE) into wall, unless
mounting screws (DD) will go directly into a stud.
Insert the mounting screws (DD) through the
holes in the back tubes and place unit against the
wall, lining up the mounting screws (DD) to the
holes in wall.
Complete the mounting by tightening mounting
screws (DD) into the studs or wall anchors (EE),
as shown.
Hardware Used
Mounting Screw
DD
EE
Wall Anchor
4. Place the assembly in the desired location and
attach the straight tube (F) to the bottom sides (E)
with screws (BB), as shown.
Hardware Used
BB
Screw
IS20065-I2
3
x 2
x 2
4
x 2
5
EE
DD
D
B
F
BB