ultega US330900000068 Manual Del Usuario página 3

Close/open
The direction of force required to open
and close is displayed on the upper
section of the trekking stick. Hold the
upper part of the stick rmly and turn
the lower section to the right to tighten
and to the left to open. Screw shut only
as tightly as required so that you are
able to loosen it again.
Note:
•
After locking the strap ensure the closures are secure by lightly leaning
onto the pole.
•
Do not tighten the poles past the "STOP" mark.
•
As far as weight restrictions are concerned, the trekking stick has a
maximum bearing load of approx. 176.37 lbs.
•
Loads over 176.37 lbs can cause damage to the damping
system, should the damping system be deactivated at
the time.
The stick refuses to close correctly ?
•
Pull each individual segment out of the
stick itself. Turn the locking system
manually 2-3 turns to the right, until the
orange clamping device starts to widen
slightly (see g.). Then place the individual stick
segments into the stick once again and x to the desired
length.
Switching cushionsion system on/off
To deactivate the cushioning system, tighten the poles, as
detailed in the "Adjusting pole length" section. Turn the
central section of the trekking pole slightly against the
screw direction. You will hear a loud click. The cushioning
system is now deactivated. Turn the central part of the
trekking pole gently in the screw direction to reactivate the
cushioning system.
Using the strap
When using the strap ensure the back of the hand is enclosed
by the top portion of the strap loop. You can detach the strap
by pulling down the button.
USA 2