Methods Of Operation - Artemis A-2001 Manual De Instrucciones

4.4 Methods of Operation

The appliance
is equipped
with ΟΝ-OFF
switch (triple
position 0 – Ι – ΙΙ
switch) placed
on the motor of
the appliance.
ΟΝ-OFF Switch
The switch
triple position
permits turning
axis to start working at place I (low
speed) or place II (high speed).
For Α-2001/Α type, the appliance
is additionally equipped, apart
from the ΟΝ-OFF switch, (see
α/α 10, §4.3), with automated
switch activated once placing the
container on its designated space.
While in operation, do not immediately
move the switch from place I to place
II. On the contrary, to move the switch
from place I to place II, move it first
to place 0 (zero) for 1-2 seconds and
then move to place II. The switch
has limited duration of life, which is
considerably reduced if not operated
according to the instructions above.
➓
➎
ENGLISH
ARTEMIS does not bear any
responsibility in case you
use the switch otherwise
than described above and its
replacement shall not be covered
from guarantee in such case.
4.5 Safety Layout
To protect the user from electrically
charged parts of the appliance, there
are fixes fenders preventing you from
accessing the dangerous areas.
Fixes fenders should be examined
on a daily basis, to make sure they
work efficiently before you start
any work with the appliance.
In case you observe any deviation
from the above mentioned, do not
start the appliance and immediately
contact ARTEMIS &Co. G.P.
➏
➑
➓ ΟΝ-OFF automated switch
(for Α-2001/Α & SUPER
MIX-2010/A type)
Lower container support
two- notch stem for Α-2001
& SUPER MIX-2010/A type
➐
➒
7