Troubleshooting - Melchioni Family BARETTO NEW Manual

PARTICULAR PRECAUTIONS
Please unplug the refrigerator before moving.
●
If there is a long distance to move, please use a cart for delivery
●
Please check if all the parts are ready before installation.
●
In order to function at its potential, this drinks cooler needs to be placed on flat floor, with 5cm spaces at
●
each side and 10 cm at the backside.
The height of the drinks cooler is adjustable by adjusting the four legs, but cannot be over 20 mm of each.
●
Keep ventilation holes clear, and keep at a distance of 50 mm from surroundings.
●
Hot food should be cooled down before placing in the cellar.
●
Do not mix uncooked food with cooked food.
●
Please keep away from the heat resources or gas.
●
Avoid direct sunshine and carry high temperature.
●
Do not place heavy articles on the top of the cellar.
●
MAINTENANCE
Shut off power supply before cleaning cabinet.
●
Take out drinks and shelves, and then clean the cabinet with soda water first and with clean water last.
●
Do not use soap or detergent for the cabinet.
●
Clean the cellar regularly.
●
TROUBLE SHOOTING
Symptoms Possible cause

No cooling



Not cold enough
temperature inside



Peculiar smell Check whether there is any sour
inside drinks cooler inside
ELECTRIC PRINCIPLE DIAGRAM
AC INPUT
Plug not put in
Low voltage
Fuse broken
The refrigerator is placed too
near heat source;
Bad ventilation;
Fans don't work;
The door is not closed tightly or
opened too frequently or for too
long time;
SMPS MODULE /
TEMP. CONTROL PCB
Solutions
Put in the plug

Ensure normal voltage

Change fuse

Keep the refrigerator away from sunshine or other heat

source;
Place the refrigerator in the area with good ventilation

and keep things away from the fans;
Check whether the plug is connected or change the fan;

Close the door tightly and don't open the door too

frequently or for too long time.
Wrap the source or take it out
TEMP. ADJ.
HEAT SINK FAN
THERMOELECTRIC
MODULE
COLD FAN