Tripp-Lite 0DT60001 Guia De Inicio Rapido página 7

9. Operating the KVM Extender USB System
The system works on a first-come, first-served basis – press the keyboard or move the
mouse at either the Transmitter (where relevant) or Receiver position to take control of
the Transmitter position computer.
Transmitter Position: Press the Lock button to keep/gain control of the computer
at the Transmitter position. The Lock LED at the Transmitter position illuminates and
blinks at the Receiver position. The Control LED at the Transmitter position illuminates.
Receiver Position: Press the Lock button to keep control of the Transmitter computer
at the Receiver position. The Lock LED at the Receiver position illuminates and blinks
at the Transmitter position.
Press the Local button to gain control of the Receiver computer position. The Local
LED blinks.
Note: You can only gain control by pressing the Lock button if the Lock LED is currently not
blinking.
Pressing the Lock button again at either position releases control and the Lock LEDs
turn off.
9.1 Keyboard Hotkeys
To toggle between the Transmitter and the Receiver position, press: Caps Lock twice,
release, then press C.
To turn the beeper sound on/off, press: Caps Lock twice, release, then press B.
9.2 Adjusting the Picture
To adjust the picture quality, use the included screwdriver to turn the Luminance and
Equalization Picture adjusters located on the Receiver's rear panel.
10. Specifications
System Cable
Maximum Distance
Mouse Support
Operating Systems Supported
Management
Screen Resolution
Operating Temperature
Storage Temperature
Warranty Period
17-04-194-9336F4.indb 7
Cat5/6/7 FTP 2x4x24 AWG solid-wire cable
500 ft. (150 m)
USB mouse
All major operating systems
Push button or external control unit
Up to 1600 x 1200 @ 75 Hz
32° to 104°F (0° to 40°C )
-40°F to 104°F (-40° to 40°C)
3-year limited
7
5/1/2017 3:05:26 PM