Audi Junior quattro Instrucciones De Uso página 10

Liability5for5product5defects
This product is covered by the statutory quality defect
liability. Damage resulting from improper use, use of
force, lack of or incorrect maintenance, or normal wear
and tear is excluded from this quality defect liability.
The vehicle has been tested and certified pursuant
to5the5DIN5EN571,5ASTM5F963,5CPSIA,5CCPSA5and5CCC5
safetyrelated standards for children's toys. As soon as
the buyer or a third party modifies the vehicle, it is pos-
sible that the test certificates will lose their validity.
Article5number
Make a note here of the article number, which can be
found on the cardboard box. This will make it easier to
order replacement parts in the future.
Toy5testing5according5to5ASTM5F963
Optional5equipment5
Audi5Junior5quattro5Pikes5peak.
Setting5up5the5LED5daytime5running5lights
This procedure must be performed with due care and
attention by an adult. Ensure that no child is allowed
to play with the toy until the batteries have been cor-
rectly installed. The car is ready to use in a few easy
steps. Battery installation should be performed in the
order shown in the illustrations.
►55 F ig.51:5Carefully5lift5up5and5remove5the5seat5cushion
►55 F ig.525and53:5Loosen5screw5and5open5battery5
compartment
►55 F ig.53:5Insert5batteries5(35x5AA5/5LR065/5Mignon),5
ensuring correct polarity and a snug fit
►55 F ig.545to56:5Screw5battery5compartment5firmly5into5
position and replace seat cushion
How5LED5daytime5running5lights5work
The daytime running lights are operated via a touch-
sensitive5sensor5(Fig.56)5in5the5cockpit5of5the5Junior5
quattro Pikes Peak. To switch on the daytime running
lights, lightly touch the sensor. The LED daytime run-
ning lights come on, which is confirmed by a red LED
indicator light in the centre of the sensor. To switch off
the LED daytime running lights, touch the sensor once
again. To prevent unintentional battery discharge, the
LED daytime running lights switch off automatically
after5around5105minutes.5Due5to5the5electronic5sensor-
based5control5system,5you5should5wait525seconds5
between switching the LED daytime running lights on
and off.
Troubleshooting5in5the5event5of5a5malfunction
►55 H ave5the5batteries5been5correctly5inserted5(polarity)?
►55 D o5the5batteries5have5sufficient5power?
►55 D o5the5batteries5make5contact5with5the5housing5
(Fig.53)?
►55 D id5you5wait525seconds5between5switching5on5and5
off?
►55 C alibration5failed.5Remove5and5reinsert5batteries5to5
restart calibration process.
Important
►55 D o5not5expose5the5car5to5moisture5or5humidity.5The5
batteries and contacts may become corroded.
►55 O nly5charge5rechargeable5batteries5under5adult5
supervision.
►55 R emove5rechargeable5batteries5from5the5toy5before5
charging.
►55 D o5not5mix5different5battery5types5or5new5and5used5
batteries.
►55 I nsert5batteries/rechargeable5batteries5with5the5cor-
rect polarity.
►55 R emove5exhausted5batteries5from5the5car.
►55 D o5not5short-circuit5battery5terminals.
►55 D o5not5dispose5of5batteries5and5electronic5compo-
nents with household waste.
English
9