allen+roth ZLQ00323 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Attach bottom base to middle base by using four
1/4 in. x 30 mm bolts (BB) and Ø6.5 x 1.5 mm
washers (CC). Guide bolts through holes in
bottom base and into pre-drilled holes in the
middle base. Do not overtighten. With the help
of another person, turn the table base assembly
to the upright position.
Hardware Used
1/4 in. x 30 mm Bolt
BB
Ø 6.5 x 1.5 mm Washer
CC
2. Attach top base to middle base by using four
1/4 in. x 30 mm bolts (BB) and Ø6.5 x 1.5 mm
washers (CC). Guide bolts through holes in top
base and into pre-drilled holes in the middl base.
Do not overtighten.
Hardware Used
AA 1/4 in. x 40 mm Bolt
CC Ø 6.5 x 1.5 mm Washer
3. With the help of another person, carefully place
the table top onto top base. Using four
1/4 in. x 40 mm bolts (AA) and Ø6.5 x 1.5 mm
washers (CC). Guide bolts through holes in the
top base and into pre-drilled holes in the table
top. Do not overtighten.
Your table is now ready for use.
UMBRELLA USAGE
If you use an umbrella, insert the umbrella pole into
the umbrella pole stopper as shown in Fig. 4. Use a
screwdriver (not included) to tighten the bolt in the
umbrella pole stopper as shown in Fig. 5. Do not
overtighten. Insert the umbrella pole to the hole of
the table top as shown in Fig. 6. Make sure the
stopper is firmly inserted into the base as shown in
Fig. 7 to prevent rotation.
M
Fig. 4
Fig. 6
Fig. 5
1
x 4
x 4
2
x 4
x 4
3
Fig. 7
4
BB
CC
C
BB
CC
A
Lowes.com/allenandroth
FOOT CAP
D
B
CC
CC
AA
CC