Lovi Protect PA103 Manual De Instrucciones página 6

Before each use:
•
Wash your hands before using the Manual Breast Pump.
•
Make sure, that all elements of the breast pump and diaphragm set have been cleaned and sterilized.
If not please follow the "Sterilization prior the first use" or "cleaning instructions".
There are two recesses for attaching the handle to the manual pump. You can toggle between these two settings by
pushing the valve stem away from the "U" shape tip of the handle to dislocate the connection. Reattach the handle
by pushing the valve stem back into the "U" shape on the handle.
•
expressing setting – tilt the handle up from the bottle as much as possible and release the valve stem base at
the same time (make sure that the handle is not separated from the hinge).
•
stimulation setting – press the handle gently towards the bottle then push it as much as possible in the
opposite direction.
Stimulation setting: Fast, shallow suction. Often referred to as the
"Let-Down" phase of pumping where the breasts begin to release the milk.
Expression setting: Longer, deeper suction. The pumping phase when
the majority of breast milk is collected.
instrukcja laktator reczny ALL (medyczny)_k002+notatki.indd 6
PUMPING INSTRUCTION
Hold the Manual Breast Pump to your breast so that your
nipple is centred inside the breastshield. Then squeeze
the handle toward the bottle to test the suction.
Note: If an adjustment is necessary, turn the round knob of the
adjusting valve until the suction is comfortable.
(invisible grooves in Stem)
You can adjust the suction level by turning the
round knob on the top of the adjusting valve.
Turn clockwise to increase the suction and
anti-clockwise to decrease it.
stimulation
expression
Increase
Decrease
(visible grooves in Stem)
6
05.10.2016 15:28:29