System Build 6383337COM Instrucciones De Montaje página 20

STEP 11
Assure that your unit is square.
Distance from corner to corner
must be equal as shown.
systembuild.com
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT
13
AND MUST BE INSTALLED PROPERLY.
Carefully turn the cabinet over on it's front side. Position Upper Back
Panel as shown. Align squarely with outer edges. Flush bottom edge
(x44)
of Upper Back Panel with bottom edge of Center Fixed Shelf (E) and
#A21110
nail straight into back edges of Left Panel, Right Panel & Top. Position
Lower Back Panel as shown. Align squarely with outer edges. Flush
bottom edge of Lower Back Panel with bottom edge of Bottom (D)
and nail straight into back edges of Left Panel, Right Panel, Bottom
& Center Fixed Shelf.
raw
surface
M
raw
surface
20
13
N
D
Flush bottom edge of the
Lower Back Panel with the
bottom edge of bottom (D).