Brigmton BPHONE-450QC Manual De Instrucciones página 14

touch the phone is currently connected wireless network, it displays the
name of the Wi-Fi network, status, signal strength, security and IP
address. If you want to remove the phone's wireless network settings,
touch this window is not saved. If you want to connect to this network,
you must re-enter these settings.
Note: Unless you choose not to save encrypted network, otherwise the
next phone to connect to the encrypted wireless network previously
connected, do not need to re-enter the appropriate password. Wi-Fi
networks on their own search, which is the phone without having to
perform additional steps can be connected to the Wi-Fi network.
Connection to other Wi-Fi networks
- Wireless and network on the screen, touch the Wi-Fi settings. Find
Wi-Fi networks will be displayed in the Wi-Fi network list.
- Touch other Wi-Fi networks can be connected to the network.
Note: In addition, the phone is also available on the Internet via GPRS.
GPRS SIM card in our current default boot is open, the user can manually
select the specific location in the Settings> SIM card management> data
connection, touch the "data connection" to close the current SIM card data
connection.
4. BLUETOOTH
Turn on Bluetooth or set the phone can be detected:
- Press menu, then touch System settings.
- Touch the wireless network, and then select the Bluetooth check box to
turn the Bluetooth function. Turned on, the status bar will appear
Bluetooth. Touch the "SEARCH FOR DEVICES" will begin to search for
Bluetooth devices within range.
- Touch the Bluetooth settings, all discovered devices are displayed in the
bottom of the list of Bluetooth devices. (Click on the Bluetooth name,
Bluetooth set to can be detected. So that other Bluetooth devices within
range will be able to find the phone.）
Important: The phone can detect the most short time of two minutes.
Pairing and connecting Bluetooth headset:
- Press menu, then touch Settings.
- Touch the "SEARCH FOR DEVICES" will begin to search for Bluetooth
devices within range. If the list cannot find your device, touch the
scanning equipment, re-scan again.
- Make sure that you want to pair with Bluetooth devices is set to the
detection mode
- Touch the headset in the device list to match.
NOTE: Bluetooth devices generally need to enter a password to pair. More
13