Cleaning The Air Filters; Cutter Plates; Maintenance And Repairs - B.Braun Aesculap Econom II GT474 Manual Del Usuario

9. Removing the cutter head
Be sure to unplug the machine before removing the cutter
head!
Remove both screws 6. Then turn the cutter head very slightly
(about 15°) counterclockwise.
The cutter head can now be removed from the motor (see fig.).
The cutter head should be carefully re-attached to the motor after
it has been thoroughly cleaned and its gear wheel has been lightly
greased (see section 6). When re-attaching the cutter head, it
should be turned 15° counterclockwise in such a way that its lower
flange engages with the groove of the motor housing.

10. Cleaning the air filters

The two air filters attached at the rear of the motor should be
removed daily for hand-cleaning (more often if they become
clogged), or for cleaning with a suitable tool such as a screwdriver.
The air filters should be thoroughly cleaned with a brush in warm
water.
After drying, the air filters should be re-attached to the machine,
which should be cleaned beforehand.
Important
Clean the air filters frequently in order to ensure that the motor is
adequately air-cooled during operation.
Under no circumstances should the machine be run without air filters
in place!

11. Maintenance and repairs

The cutter head should be cleaned after every few days of shearing
time.
To do this, remove the cutter head from the motor housing (see
section 9) and the cutter plates (see section 7).
Then use a soft cleaning brush or paintbrush to give the interior
surfaces of the cutter head and other unit components a thorough
cleaning.
After carefully reassembling the machine, the cutter head should
be oiled according to the instructions in section 5.
In order to avoid damaging the unit, we recommend that you
contact your dealer, who can supply you with replacement parts,
and can also repair your machine properly.
Before any work is done on the machine, it should always be
unplugged!
8
Horse and cattle shearing machine GT474/GT674 and cutter head GT367
12. Service addresses
Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone: +49 (0) 8086 933-100
Fax: +49 (0) 8086 933-500
E-mail: info@kerbl.com
www.kerbl.com
Other service addresses can be obtained from the address indicated
above.
13. Storage
Store the machine and the cutter plates (which should be oiled) in
a clean and dry place.

14. Cutter plates

Cutter plates compatible with cutter head GT367
GT501 Upper cutter plate with 15 teeth
GT503 Upper cutter plate with 17 teeth
GT505 Upper cutter plate with 23 teeth
GT502 Lower cutter plate with 31 teeth,
cutting depth 3 mm
GT504 Lower cutter plate with 18 teeth,
cutting depth 3 mm
GT506 Lower cutter plate with 23 teeth,
cutting depth 3 mm
GT508 Lower cutter plate with 51 teeth,
cutting depth 0.1 mm
GT510 as GT506, but cutting depth 5 mm
GT511 as GT502, but cutting depth 1 mm