Publicidad
Idiomas disponibles
Idiomas disponibles
Lengthwise Cut
Insert the floor plank between the
cutting blade and the working table
along with the guide bar from the
side way. The guide bar may be
locked on both sides of the working
table. Keep moving the plank along
with the guide bar after each cut
until the plank is completely cut.
Notch Cut
Make a lengthwise cut first to
desired length on the floor plank as
mentioned above, then turn the
plank 90°, and put desired cutting
point right under the blade.
Unlock two screws on the blade
holder and pull out the blade as
shown to above mentioned desired
cutting point, then pull the handle
down to complete a cut.
Changing the Blade
First loosen the screw on the blade
holder and then remove the stopper
screw, holder and pull out the blade
as shown. Use included Allen
wrench to remove the six screws,
then carefully move the blade out of
the small blade holder.
Note: the flat side of the blade
should face the working table.
Warning: Do not put your fingers
against the sharp edge of the blade
at any time.
4
Publicidad
