Reelcraft LG3050 143 10 Instrucciones De Operación página 2

Bracket hole pattern
Retractable Industrial Extension Cord Reel
Fig. 1
6. The reel can now be installed into the bracket. The following
Bracket A
installation instruction will allow smooth retraction:
a. When the mounting height is less than 5 ft, the reel should
be positioned so that the cord opening face upward (Fig. 3).
b. When the mounting height is more than 5 ft, the cord
opening should face downward (Fig. 4).
7. Slide the mounting pin (B) through bracket and reel. Slide the
locking pin (C) through the Mounting Pin for security. Fig. 2
Wall Mount
5Ft or Below
B
A
C
Fig. 3
Ceiling Mounting (Fig. 5)
1. Pick the approximate location for the reel within 2 1/2 ft. of a
110-125V Standard Ground Outlet.
2. Locate a joist or beam to install the mounting bracket. The
bracket should be placed
directly over the center of the
joist or beam.
3. Using the bracket as a tem-
plate, mark the (3) screw
locations with pencil. (Fig.1)
4. Pre Drill (Pilot) the three
screw holes with the use of
at 1/4" drill. The depth of
the Pilot holes should be at
least 2".
5. Install the bracket with the
(3) provided hex head wood
screws with washers using
a 1/2" wrench or socket.
Tighten all three until snug.
6. The reel can now be installed
into the bracket. (Fig.5)
7. Slide the mounting pin (B) through bracket and reel.
WARNING: Slide the locking pin (C) thru the Mounting Pin (B) for
security. It will prevent the mounting pin from sliding out of posi-
tion.
Page 2
3 - #5/16" HEX SCREWS
Wall Mount
Above 5Ft
B
A
C
Fig. 4
C
Fig. 5
NOTE: When Ceiling Mounting is to be against at steel beam, a
Professional Installer should use minimum 1/4" bolts with lock
washers or locking nuts.
HANGING WORK LIGHT (Fig. 6)
The Multi-position Hanging
Hook (B) can rotate 360° for
precise positioning. Magnet (C)
clings to most metal surfaces.
LAMP REPLACEMENT
DO NOT ATTEMPT TO REPLACE
LED ELEMENTS. If properly
maintained, the LED's will pro-
vide up to 50,000 hours of use.
OPERATION
Plug into any 110-120V grounded wall outlet. Depress switch in
handle to turn the light on. To operate the cord reel, pull cord out
to the desired length, then slowly release tension on the cord.
If cord does not hold its position, continue to pull cord out until
click(s) is heard. Release cord slowly until cord retraction is
locked. To retract the cord, pull until the click(s) are no longer
heard, normally between 4 to 12 inches. The cord can then will
then retract into the reel.
1. Outlet is un-switched and energized when "Power-On" indi-
cator is illuminated. Use as needed up to a 13 Amp. 1560
Watts, 120V load. DO NOT OVERLOAD !
2. Cord length is 50 ft fully extended; DO NOT pull on cord after
cord is fully extended.
A
Caution: To Avoid Possible Injury - Do not allow cord to fly back
into the reel unrestricted. Guide cord slowly back into the reel.
B
B
C
A
Fig. 6
www.reelcraft.com