Peak 3D MULTIHORSE 5201 Manual Del Usuario página 7

3. Install 2x4 Spacers into brackets and fasten at
each end with #10x1¼" (32 mm) wood screws.
4. Flip the plywood sheet over and fasten the brackets
to the Long Stringers using eight #10x1¼" (32 mm)
wood screws.
Ensure Table top does not
extend outward
more than 6" (152
mm) past brackets.
5. Install legs by releasing leg clamps,
inserting legs through leg clamps and sliding
to desired height.
Install Boots - refer to Sawhorse
Assembly Instructions, Step 3, for
Boot installation.
6. Carefully turn structure over
with the help of another person.
IMPORTANT:
Legs must
never exceed 3'
(0.91 m) long.
Ensure each leg
clamp is fully
engaged.
IMPORTANT:
Ensure top
end of each
leg extends
beyond
top of each
bracket.