Ega Master 60090 Manual De Instrucciones página 8

- It is very important to check the oil level.
- It is recommended to change the oil periodically, if it works in dirty environments and if it is
done in continuous connections and disconnections of hose (at least once a year).
- Before adding the oil, it is recommended to filter to eliminate impurities.
- Both the cable and the plug must be in optimal conditions. Inspect them regularly.
- It is also recommended to change the gasket when this is spoiled.
- In case of work in corrosive or aggressive environments protect the machine and clean it
regularly.
IMPORTANT!
- Before doing any work on the machine, disconnect the plug from the power point.
- Repairs should be done by specialized personal.
Problem
1. 1.
2. Breakage of the cable cover or defects
The electric
motor does not
3. Defects in the plug
spin.
4. Overheating of the engine
5. Faulty engine
Problem
1. Too low level
2. Loosening of the connecting hose
The piston
3. Air in the system
rod moves
erratically or
4. Dirt on the pump or filters
partially.
5. Frozen oil or oil too thick (The
6. Low pressure by wear.
8
POSSIBLE SOLUTION TO PROBLEMS
Cause
The unit is not connect
in the bead or terminal connections
Cause
between the pump and the pipe
bender
hydraulic oil has a higher viscosity
than necessary)
MAINTENANCE
1. 1.
point
2. Replace the defective parts
3. Check and replace, if necessary
4. Allow the engine to cool before
starting again
5. Repair or replace the engine.
1. Fill with oil through a funnel with the
piston rod retracted until reaching
the level
2. Check the connections and tighten
if necessary. Check the loosening of
fittings.
3. Purge the system or the suction line,
if necessary
4. Clean the pump filter, and if
necessary, to dismantle the pump
and inspect and clean all their parts.
5. Change to a lower viscosity
6. Repair or replacement the needed
parts.
Solution
Connect the unit to the power
Solution