Bissell VAC & STEAM 1977N Manual De Instrucciones página 10

Maintenance & Care
Cleaning Hose Tube
1. Grab bottom end of the hose and pull
lower portion away from the body.
2. Seperate the hose into two pieces.
3. Wash hose and wait for it to dry.
4. Align the top of the hose to the groves
on the hose opening of the unit.
5. Twist hose down to insert lower portion
of hose to the unit.
6. Make sure hose fits tightly into the unit.
Cleaning Foot of Unit
1. To clean the foot and bristles, push the release
button on the back of the pivot joint and pull the
foot to release it from the appliance.
2. Wash bottom of foot and bristles with
cold water.
3. Look for any clogging in the steam nozzle.
To clean, run water over steam nozzle.
NOTE: Make sure foot and bristles are dry
before attaching the foot to the appliance.
4. To re-attach the foot to the appliance: place
the foot on the floor, push the appliance down
into the foot and then listen for the click that
sounds when properly attached.
10
www.BISSELL.com
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
1.
5.
2.
3.
6.