Publicidad
Enlaces rápidos
Publicidad
Manuales relacionados para Subzero SZ-DMR-200
Resumen de contenidos para Subzero SZ-DMR-200
- Página 1 ROTARY DJ MIXER SZ-DMR-200/ SZ-DMR-400 USER MANUAL...
- Página 2 WARNING! VAROITUS! Do not open cover. No user-serviceable parts inside. Refer servicing to qualified Älä avaa kantta. Ei sisällä käyttäjä-huollettavia osia. Huollot saa suorittaa vain pätevä service personnel huoltomies. Do not place the product in a location near a heat source such as a radiator, or in an Älä...
- Página 3 ADVARSEL! OPOZORILO! Ikke åpne dekselet. Inneholder ingen deler som kan brukes. Overlat reperasjon til Ne odpirajte pokrova. V notranjosti ni nobenih delov, ki jih uporabnik lahko sam kvalifisert servicepersonell. popravlja. Popravilo prepustite usposobljenemu osobju Ikke plasser produktet i nærheten av varmekilder som f.eks. en radiator, eller i Ne postavljajte izdelka na lokacijo v bližini vira toplote, kot je radiator, ali na območje, områder som er utsatt for direkte sollys, mye støv, mekanisk vibrasjon eller støt.
-
Página 4: Product Features
INTRODUCTION Thank you for choosing the SubZero DMR-200/400. This user manual will show you how to install and operate the mixing console. Users of this product are recommended to carefully read all warnings in this manual and on the unit in order to protect yourself and others from injury. - Página 5 PARTS AND FUNCTIONS DMR-200 PHONES ∞ ∞ ∞ +9dB +9dB +9dB HIGH CH 1 CH 2 PH 1 / LINE 3 PH 2 / LINE 4 HIGH –10 –10 HIGH CH 2 OUTPUT CH 1 INPUT: TBC FUSE: TBC MASTER —...
- Página 6 17. SELECTOR SWITCH FOR THE HEADPHONES 28. PHONO SENSITIVITY MONITORING MODE Gain control for matching the input amplification of phono input 2 to line level Button pressed (SPLIT): the prefader level sources . (mono) is on one side of the headphone and 29.
- Página 7 PARTS AND FUNCTIONS DMR-400 300Hz 4000Hz PHONES ∞ ∞ ∞ +9dB +9dB +9dB HIGH CH 1 CH 2 CH 3 CH 4 PH 1 / LINE 1 PH 2 / LINE 3 PH 3 / LINE 5 PH 4 / LINE 7 HIGH –10 HIGH...
- Página 8 6. INPUT SOURCE SELECTOR SWICTH 19. SELECTOR SWITCH FOR THE HEADPHONES (CH 1 TO 4) MONITORING MODE Input source selector switch for channel 1-4: Button pressed = phono/line (LED lights), • Button pressed (SPLIT): the pre-fader level Button released = line (LED off) (mono) is on one side and the output signal (mono) is on the other side of the headphones.
- Página 9 29. BOOTH OUTPUT (PHONO) Stereo output (RCA) for connecting a further amplifier, e.g. for the monitoring system or PA application in a secondary room. 30. RECORD OUTPUT Stereo output (RCA) for connecting a recording unit. OPERATION POWERING UP To protect your audio equipment, specifically your speakers, follow this power-up sequence: 1.
- Página 10 SPECIFICATIONS NOTE: HEADPHONES All specifications apply to both the DMR-200 and DMR-400 unless otherwise stated. Headphones ... . . 6.3 mm jack (min. 32 Ω) POWER 3.5 mm jack (min. 32 Ω) (DMR-400 only) Power supply .
- Página 11 If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com...