Low Battery Warning - AmazonBasics B07GDYVN47 Manual Del Usuario

Opening Safety Device with Security
Code
• With your correct personal code entered (factory pre-set code is 1-2-3-4), the button lights will
light up blue and the safety device will automatically open. If the code is entered incorrectly, the
button lights will flash red five times with five audible beeps.
Opening Safety Device with Registered
Fingerprint
• Press your registered finger to the biometric scanner, the scanner light will light up blue and the
safety device will automatically open. If the fingerprint is invalid, the scanner light will flash red
five times with five audible beeps.
Entering the Wrong Code or Invalid
Fingerprint
• If the wrong code or invalid fingerprint is entered five consecutive times, the safety device will go
into a lock-down mode for five minutes. During this period all lights will flash red when pressing
any buttons and the electronic keypad will be temporarily disabled. The safety device may still
be opened using the emergency key override. After a five-minute period the safety device will
automatically resume normal operation.
Turning off the Audible Sound
• To silence the audible sound of the electronics, hold the button "1" until all lights flash blue
once. To unmute the keypad, repeat above step.

Low Battery Warning

• If the 4 AA batteries drop below the required voltage, after entering the correct personal code
or valid fingerprint, the lights will light up blue once when the door is open, then flash yellow five
times with five beeps.
• In this case, you will need to replace the batteries.
6