Parktool SG-7.2 Manual De Instrucciones

PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
SG-7.2 Oversized Adjustable Saw Guide
• Accurately guides a hacksaw to cut fork columns, aero seat posts, and
integrated seat tubes
• Two cutting slot widths for standard and carbon composite cutting blades
• Works on aero tubes up to 2.75" (70mm) and round tubes from 1-1/16"
(27mm) to 1-3/4" (45mm)
Instructions:
1. Mark desired location of cut on tube.
2. Clamp tube in a Park Tool Repair Stand and rotate to the
horizontal position.
3. Slide SG-7.2 on tube until mark is visible through the cutting slot. Use the
narrow slot if using a standard hacksaw blade. Use the wider slot if using a
blade specifically for cutting carbon composite. Tighten handle to secure.
When cutting an aero tube, position narrow part of tube in center of
floating V block (ref. #3).
4. Set blade of hacksaw in cutting slot and saw through tube. Do not apply
excessive pressure on the blade. Keep hacksaw traveling straight down
the slot. Always use a sharp blade. Use of a dull blade may result in an
inaccurate cut.
5. Loosen handle and slide SG-7.2 on tube to
expose cut end of tube. For metal tubes,
finish outside and face of tube with a flat
file. De-burr inside of metal tube with
a round file or de-burring tool. Finish
end of carbon composite tube with fine
sandpaper.
6. Remove SG-7.2 from tube.
SG-7.2
Instructions / Instructions / Anleitung / Instrucciones
SG-7.2 PART NUMBERS
Ref. # Part # Description
1 796R Body Assembly
794C Handle Assembly
2
3 797 Floating V Block
4 795 Fender Washer
Flanged Button Head
5 724
Screw M3x8
6 800-2 Frame Pad
7 467-1 Retaining Clip
8 160 End Cap
3
6
Qty.
1
1
1
1
1
2
4
2
1
4
5
8
2
7