Removal/Replacement and Adjustments
Upper Transport Cover Removal/Replacement
The Upper Transport Cover should be removed for clearing stoppages and during
machine maintenance.
Upper Transport Cover Removal
1. IMPORTANT: Turn the machine OFF before proceeding.
2. Press the Upper Transport Cover Latch to the left, grasp the right end of the
cover and lift upwards to remove. See images below.
Press Latch
3. Reverse this procedure to re-install the Upper Transport Cover.
The DL400 will not operate until the Upper Transport Cover is properly
installed.
The Upper Transport Cover must be removed in order to increase or
decrease the cut depth, see Cutter Adjustment across the page.
SDC965B DL400 Operator Guide
Lift Cover
Cutter Adjustment
The Cutter on the DL400 can be adjusted to accomodate different mail types. Manual
adjustment allows for a deeper or shallower cut than adjustment via the Cutter
Adjustment Lever.
Adjusting the Cutter Depth
1. Remove the Upper Transport Cover (see previous section).
2. Reference the above image and make adjustments as required.
a. For a deeper cut press the release button and with a flat head
screwdriver turn the Cutter Adjustment Cam clockwise to increase
the cut.
b. For a shallow cut press the release button and with a flat head
screwdriver turn the Cutter Adjustment Cam anti-clockwise to
decrease the cut.
3. Replace the Upper Transport Cover.
EN
Cutter
Adjustment
Cam
Release
Button
<< Return to Contents