Phones Jack - FIRST AUSTRIA FA-1925-1 Manual De Instrucciones

(A) select the 20th song, just press digital button "2" and "0".
(B) select the 128th song, just press digital button "1", "2" and "8", then the unit will
play the 128th song.
2. At the Radio mode, press the digital button to select the relevant radio channel, for
example:
(A): Press digital button „"2" and "0" to select the channel 20
(B): If try to select the FM frequency 98MHz, just press digital button "9", "8" and "0" ; If
try to select the FM frequency 107.5MHz, just press digital button "1" , "0", "7" and "5".
ALARM CLOCK, TIME SETTING AND SLEEP SETTING
A. Alarm clock
1. Hold "PLAY/PAUSE" button to power on, press digital button "6" more than 2-3
seconds for the alarm clock mode, press digital button "6" more than 2-3 seconds,
the "HOUR" position of the clock will be twinkling, press the Volume "+"/"-" button
to adjust hour number, and hold the digital button "6" shortly again, the "Minute"
position will be twinkling, press the Volume "+"/"-" to adjust the minute setting,
then press the digital button "6" shortly again, just exit the clock setting and save
accordingly.
2. Once the set time of the clock is coming, it will make "di di di···" sound, press any
button to cancel the clocking, and the unit will keep the alarm clock function in the
same time of next days. If no any operation once the clock is alarming, it will stop
after 3 minutes.
3. The alarm clock can be turn on or turn of just by press the digital button "2" more
than 2-3 seconds, TURN ON like picture 1, TURN OFF like picture 2
B. Time setting
The way of the time setting is the same as the setting of the alarm clock, but just
press the digital button "1", not "6".
C. Sleep setting
1. Press the digital button "3" more than 2-3 seconds for the sleep setting, then hold the
digital button "3" shortly to increase 15 minutes, the highest setting is 90 minutes.
2. If the setting time of the sleep mode is 00, just turn off the sleep function
*** If take out the battery of this unit, then must reset the setting of the time, alarm
clock and sleeping.
AUX IN FUNCTION
This unit can be an amplifier for any audio output device (cell phone, MP3 player,
cassette player, CD player, radio receiver, etc). The method is to use the AUX INPUT
cable to connect the audio out put device to this player, press MODE button to transfer
to AUX function, then switch on this player, then it is OK.

PHONES JACK

Put your earphone in the phones jack, then you can listen to the music through
earphone
Caution: Listening at high power for a long moment could damage users' ears.
RADIO FUNCTION
1. Press "M" button to radio status, press PLAY/PAUSE button, the player will start
searching channels, the player will store the channels it searched, it can store no
less than 30 channels. Press PREVIOUS/NEXT button to select lower and upper
saved channel.
4
2. In radio status, keep pressing PREVIOUS or NEXT button, then you can search
lower and upper channels manually.
USB SOUND CARD FUNCTION
Connect USB line to the computer, at the status of power OFF, Once USB speaker
connected, press the VOLUME up and down to increase or reduce the volume. Or
adjust the volume directly by the computer operation. Press MODE button to exit the
USB speaker function and turn into power charging mode.
PC SPEAKER
For the device without USB stick and in Power off status ,connect it to a computer by a
USB cable( which allows data transfer):
Switch on the device and the LCD shows"PC" In this status the device act as
a computer speaker.
CAUTION
• The apparatus shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
• Minimum distances 5cm around the apparatus for sufficient ventilation.
• The ventilation should not be impeded by covering the ventilation openings with
items, such as newspapers, table-cloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the
apparatus.
• When the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
To be completely disconnected the power input, the mains plug of apparatus shall be
disconnected from the mains completely.
The main plug of apparatus should not be obstructed or should be easily accessed
during intended use.
• The use of apparatus in moderate climates.
• Attention should be drawn to the environmental aspects of battery disposal.
• Batteries shall not be exposed to excessive heat such as sunshine,fire or the like.
About Battery Pack
This unit works either on the supplied battery pack (DC 3.7V, 800mAh rechargeable
battery) or the AC power: unplug the AC Power adapter from the DC input jack to work
on the battery pack (after fully charged); plugging the AC Power adapter while the
battery pack is attached initiates the charging of this battery. The charge LED indicator
light will be on when the battery is being charged. After 3-5 hours continueous charge,
the battery will be fully charged.
A fully charged battery pack can endure approximately 2-3 hours of continuous
playback. This playing time may vary with the surrounding environment, the volume
level of the speaker and the battery condition. It is advised that you wait 10-20 minutes
before recharging the battery pack if it has turned flat during operation.
• Excessive sound pressure from earphones and headphones can cause hearing loss.
Environment friendly disposal
You can help protect the environment! Please remember to respect the local
regulations: hand in the non-working electrical equipments to an appropriate waste
disposal center.
5