Chain Tension - Kamikaze KVS 2000 Manual De Uso

ELECTRONIC SAW
15.2 CHAIN AND BAR DISASSEMBLY
• Disconnect the battery from the chainsaw.
• Use Allen wrench supplied to unscrew the two locking nuts (1) and remove
the cover (2).
• Unscrew the chain tension adjusting screw (3) to loosen the tension.
• Remove the chain and bar.
15.3 CHAIN AND BAR ASSEMBLY
• Disconnect the battery from the chainsaw.
• Adjust the tension adjustment bolt (3), place the bar on the chainsaw body (4)
and insert the guide plate fixing column (5) into the fixing hole (6) on the bar.
• It is possible to use the front or back of the bar.
• Insert the chain into the bar slot and refer to the arrow on the pinion cover to
understand the correct direction of the chain.
• Assemble the pinion cover and tighten the two locking nuts (1).

15.4 CHAIN TENSION

Cuando se utiliza la motosierra, la cadena se sobrecalienta y puede estirarse. Si es
necesario, ajuste la tensión de la cadena de la siguiente forma:
• Disconnect the battery from the chainsaw.
• Use the Allen wrench supplied to slightly loosen the two locking nuts (1).
• Screw (to increase the tension) or unscrew (to decrease the tension) the chain
tension adjustment screw (3).
www.kamikazevolpi.com
91