Harman JBL STADIUM BASSHUB Manual Del Propietário página 3

CONNECTING THE WIRING
HARNESS
To connect the speaker wiring harness to the input on the
right side of the Stadium BassHub:
1. Use the included 2.5mm Allen wrench to remove two
screws securing the cover on the top panel of the
Stadium BassHub.
2. Lift off the cover.
3. Insert the harness into the input.
EN
WIRING THE STADIUM BASSHUB TO
YOUR AMPLIFIER
The Stadium BassHub features dual 4-ohm voice coils that
can be wired in series for an 8-ohm impedance load or in
parallel for a 2-ohm impedance load. Be sure to observe
proper wire polarity.
Plug diagram:
For parallel wiring:
1. Connect the SUB1+ and SUB2+ wires to the + output on
the amplifier.
2. Connect the SUB1- and SUB2- wires to the – output on
the amplifier.
For series wiring:
1. Connect the SUB1+ wire to the + output on the amplifier.
2. Connect the SUB2- wire to the – output on the amplifier.
3. Splice the SUB1- and SUB2+ wires together.
IMPORTANT: Make sure your amplifier is compatible
with your desired impedance load. Connecting a 2-ohm
impedance load to an amplifier that is not rated for 2 ohms
can cause the amplifier to overheat and malfunction or
damage the vehicle.
SPECIFICATIONS
• Power handling: 600W RMS, 1200W peak
• Frequency Response: 20Hz – 150Hz
• Sensitivity (@2.83V/ 1m): 90dB
• Voice Coil diameter, each: 2.5in. (64mm)
• Impedance: Dual 4 ohms
• Dimensions (D x H): 14-3/16" x 6-1/2" (D360mm x
H164.5mm)
2Ω Parallel Wiring
SUB1+ and SUB2+
SUB1- and SUB2-
8Ω Series Wiring
SUB1+
SUB1- and SUB2+
SUB2-