Precautions; Operate The Sleeve Board; After Use / Transport Elnapress - Elnapress 250S Manual De Instrucciones

PRECAUTIONS

— Remove the vaporizer from the handle when you stop or finish ironing.
— Place Vapojet vertically (cap below) to prevent drops of water from falling.
— Empty the vaporizer after use.
— At the end of ironing, close and open the still warm press for a few times,
without linen, to dry and protect the cover and the padding.
— Do not put starch in the water.

OPERATE THE SLEEVE BOARD

ELNAPRESS 250 / 450 / 450SE
Place your hands on the surface of the Sleeve board and rotate it upwards.
Once the locking device is activated, at the stroke end press firmly until you
hear the click.
20 20
AFTER USE
Turn off Elnapress following the instructions on page 15-16.
Remove and empty the Vapojet. While the press is still hot, open it and close
it several times to let the board cover and foam padding dry. Leave the press
open until it is completely cold.
As mentioned in the "Safety Features" section if the press is switched off and
closed while the plug is still inserted, a safety alarm will be triggered if the
specific internal "product safeguard" sensor detects a temperature = /> 65°
after 45 min. from its switching off.
N.B. Do not close or block the press before it has cooled.
This operation is only possible if the optional accessory "Protective sheet" is
used (see accessories list page. 24-25).
TRANSPORT ELNAPRESS
Always close the press and lock it with the appropriate safety hook before
moving it. To store it, take it by the fixed handle.
21