Publicidad
Furniture Wall Safety Strap
Hardware list
A
B
CONNECTOR
STRAP
4 PCS
2 PCS
WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE FURNITURE MAY TIP OVER. PLEASE INSTALL THE SAFETY
WALL STRAP BEHIND THE FURNITURE TO ENSURE SAFETY.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT AND KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE CALL OUR CUSTOMER SERVICE NUMBER: 1-800-
295-1980.
PLACE THE CONNECTOR (A) ON THE BACK EDGE OF THE FURNITURE AND MARK IT ON THE WALL. USE AN ELECTRIC DRILL (NOT INCLUDED) TO DIG
Step 1:
THE HOLES.
INSERT THE PLASTIC SCREW ANCHOR (E) INSIDE THE HOLES. INSTALL THE LONG SCREW (C) BY USING A SCREWDRIVER (NOT INCLUDED)
Step 2:
INSTALL THE SHORT SCREW (D) AND THE CONNECTOR (A) INTO THE RIGHT SIDE PANEL BY USING A SCREWDRIVER (NOT INCLUDED)
Step 3:
PLACE THE FURNITURE IN SUCH POSITION THAT BOTH MOUNTING BRACKETS ARE VERTICALLY IN LINE. LACE THE END OF THE SAFETY WALL
Step 4:
STRAP (B) THROUGH THE LARGER HOLE IN EACH MOUNTING BRACKET (A). BRING BOTH ENDS TOGETHER AND SLIDE THE FLAT END THROUGH THE
LOCKING END AND DRAW IT THROUGH UNTIL ALL SLACK IS REMOVED.
Step 5:
ENSURE THAT THE STRAP (B) IS SECURELY LACED AND LOCKED.
TO MOVE THE FURNITURE AFTER THE SAFETY WALL STRAP HAS BEEN INSTALLED, SIMPLY REMOVE THE SCREW FROM THE WALL TO LOOSEN THE
SAFETY WALL STRAP.
C
D
LONG SCREW
SHORT SCREW
4 PCS
4 PCS
E
PLASTIC
SCREW
ANCHOR
4 PCS
Publicidad
