Couture Creations GoPress and Foil Manual Del Usuario página 6

HOT FOILING WITH CHIPBOARD
Accessories needed:
• Chipboard or thin wooden piece
• Heat activated foil
1.Turn the mains power switch on for your foiling machine. A red light will come on when
plugging in. With your Heating Platform connected to your base unit, when you press
the button on the base unit the red light will commence to flash on and off. This light will
then turn green once it reaches working temperature ( this will take approximately 5 – 6
minutes ). The machine will automatically switch off after the machine is left unused for
over 25 minutes ( The red indicator light will come on ).
2. Please note that the heating platform will maintain a maximum temperature of
approximately 90°C / 194°F as it has a built in automatic thermostat.
3. Lift up the Heating Platform clear protector lid. Place your chipboard or thin wooden
piece on the Heating Platform (facing downwards) on the black non slip surface mat.
Close the Heating Platform clear protector lid.
4. Let your chipboard or thin wooden piece heat for approximately 1 minute. While
your foiling machine heats up prepare and cut your heat activated foil to the size of your
chipboard or thin wood piece in preparation for foiling.
5. Lift up the Heating Platform clear protector lid and place the heat activated foil directly
onto the Heating Platform (black non slip surface mat coloured side of the foil facing
down). Then place your chipboard or thin wooden piece on top of the foil.
6. Place a shim (piece of large cardstock) over your project.
7. Close the Heating Platform clear protector lid, remove it from the base unit and place
the platform into the opening of your cutting machine. Wind through as per normal.
NOTE: YOU ONLY NEED A VERY SLIGHT AMOUNT OF PRESSURE, IF YOU HAVE
TOO MUCH PRESSURE YOU WILL DAMAGE YOUR HEATING PLATFORM.
8. You will now have the foil transferred onto your chipboard or thin wooden piece.
9. Remove the foil from the surface of the chipboard or thin wooden piece and your item
is now complete.
THE CHIPBOARD OR THIN WOOD PIECE WILL BE HOT. PLEASE ONLY
*
USE THE PICK N LIFT 3 IN 1 MAGIC TOOL TO PICK IT UP.
All manuals and user guides at all-guides.com
AND THE GOPRESS AND FOIL
PAGE 6