Horizon Global 75540 Instrucciones De Instalación página 4

1. Remove tie down bracket – Using 17mm socket, remove (2) bolts from tie down
bracket on passenger side. Return tie down bracket to vehicle owner.
3. Trim lower fascia (for model year after 2021) – Using flat head screwdriver, remove two tabs from sensor bracket behind lower fascia if sensor bracket is present. Using tape and
marker, locate the centerline from the edge of bottom tab and mark a 3''x 3'' trimming area based on centerline. Using hacksaw, trim the fascia area highlighted and do not cut on
sensor bracket.
©2021 Horizon Global™ Corp - Printed in Mexico
2. Remove weldnut covers – Using flat head screwdriver, remove (2) plastic caps from
rearmost existing weldnuts on the driver side. Remove the rearmost rubber plug from
the hole between the two weldnuts that were exposed earlier on the driver side.
3.00''
3.00''
Centerline
Sheet 4 of 24 75540NP 5-17-21 Rev. D